Configuring RIP between HP ProCurve and Cisco Switches

integrating IT

 

I needed to distribute routes between an HP ProCurve and a Cisco Catalyst switch. The HP ProCurve switch mode used was a 3500-48yl without the premium license; therefore I was only able to use RIP and not OSPF. The Cisco switch used was a Catalyst 3560-8 IOS 12.2(55) IPBase. You will notice from the configuration below the difference in commands between the ProCurve and Cisco switches.

 

ProCurve Switch Configuration

ip routing
vlan 900
name « VLAN900 »
untagged 48
ip address 10.0.0.2 255.255.255.0
exit
router rip
no auto-summary
redistribute connected
enable
exit
vlan 900
ip rip 10.0.0.2
exit

 

Cisco Switch Configuration

ip routing
interface GigabitEthernet0/1
no switchport
ip address 10.0.0.1 255.255.255.0
interface loopback 1
ip address 192.168.1.1 255.255.255.0
router rip
version 2
redistribute connected
network 10.0.0.0
no auto-summary

Verification

Running « show ip route » on the ProCurve switch you can see the 192.168.0.0/24 route is learnt via RIP

 


 

View original post 1 mots de plus

Advertisements
Par défaut